JRC JMA-5212-4/6 - Page 285

5.3 AIS OPERATION
544
5
yy
yyy
Displaying numeric data
Procedure 1 Press the CURSOR button at the upper right of the radar display
several times until
TGT DATA appears.
The cursor mode is set to the numeric data display mode.
2 Move the cross cursor mark onto the active AIS target for which numeric
data is to be displayed, and press [ENT] key.
The values of the selected AIS target will appear on the right side of the radar display.
The mark is displayed around the symbol.
Reference:
If the values are displayed but the mark . is not on the radar display, the target is outside the
radar display.
Clearing numeric data
Procedure 1 Press the Cursor button at the upper right of the radar display several
times until TGT Data appears.
The cursor mode is set to the numeric data display mode.
2 Move the cross cursor mark onto the active AIS target for which numeric
data is to be cleared, and press [CLR] key.
The values of the selected AIS target will be cleared from the right side of the radar
display, and the mark displayed around the symbol will also disappear.