– 152 –
Trouble Cause (1) Cause (2) Check and corrective measures
From the previous page
8-5) Pressing is inappropriate. 5-A) The presser is oating. Readjust the position of the presser bar holder.
5-B) The parallel level of the presser
is inappropriate.
Replace the presser, or loosen the presser bar
holding screw and correct the foot bend.
5-C) The pressure is too low. Increase the pressure of the presser.
8-6) Threading is inappropriate. 6-A) Threading of the needle thread
is improper.
Correct threading.
6-B) The needle bar thread guide is
defective.
Try using B1418227T00 or B1418552A00.
9. Material ber breaks.
Material bers are broken by the
needle during sewing.
9-1) The needle is defective. 1-A) The needle heat is too high. Use silicon.
1-B) The needle is too thick. Use a needle as thin as possible.
1-C) The needle tip is blunt. Replace the needle.
1-D) The shape of the needle tip is
inappropriate. (Different needle
type)
Use a ballpoint needle. (KN, S, J, B, U, Y, etc.)
9-2) The sewing speed is too high. Reduce the sewing speed. (Prevention of nee-
dle heat)
9-3) The material is excessively
tense.
3-A) The needle hole of the throat
plate is too small.
Use a throat plate with a larger needle hole.
3-B) The pressure is too high. Reduce the pressure as low as possible.
3-C) The height of the presser tooth
is too high.
Lower the height of the presser tooth as low as
possible.
9-4) The room humidity is too low. Keep the humidity at approx. 65% to prevent
needle heat, electrication, and friction.
9-5) The feeding pitch is too small. Increase the feeding pitch as large as possible.
To Next Page
Loading...
Need help?
General
