– 85 –
(5) Password lock (Memory switch No. 14)
1) Activate the memory switch in the service level.
(Refer to "4.-(2)-[2] Service level".)
2) Press
❼
to make the pressing
setting No. A blink, and press
❻
to
select "J14".
❼❻
❽
⓬
A
B
❼❻
❽
⓬
3) Press
❼
to flash the setting item B. In this state, set a 4-digit password by
pressing
❻
.
(Cautions) Write down the password you have set so to remember it.
4) Press
❽
to determine the password and press
⓬
to return the normal sewing state.
5) If the password is other than "0000", trying
the activation of the memory switch displays
the password input screen before the function
setting screen is displayed.
6) Enter the four-digit password you have set to the [function setting No. J14] using
❼
and
❻
.
7) The function setting screen is displayed by pressing
❽
. On this screen, the functions can be set.
[How to clear the password]
If you forget your password, you can clear the password by turning on the power while simultaneously
pressing
, and .
To Next Page
Loading...
Need help?
General
