JUKI DDL-8000A Engineer's Manual

– 14 –
Adjustment Procedure Results of Improper Adjustment
[Adjustment of the presser pressure]
1. Loosen the nut ❷ and turn the presser adjusting screw ❶.
Turning in Direction A for strengthening
Turning in Direction B for weakening
2. Tighten the nut ❷ after adjustments.
* Standard value of the presser adjusting screw height C
Specications
Height mm
🅒
Presser
Pressure N
Presser
Pressure kg
DDL-8000A*-MS 29.5 39.2 4
DDL-8000A*-SH
(DDL-8000A*-SJ)
29.5 60 6.1
(The presser adjusting screw varies depending on the specication.)

JUKI DDL-8000A Specifications

General

Stitch Type	Lockstitch
Motor Type	Direct-drive motor
Thread Trimmer	Automatic
Max. Stitch Length	5mm
Needle Bar Stroke	30.7mm
Lift of the Presser Foot	By hand: 5.5mm, By knee: 13mm
Control Panel	Digital
Lubrication	Automatic