JUKI DDL-8000A Engineer's Manual

– 24 –
Adjustment Procedure Results of Improper Adjustment
4) Cleaning of the oil lter
Clean the oil lter ❷ periodically (approximately once every three
months).
1. Let the sewing machine fall down.
2. Remove the pipe stop ❶ and then the thread waste attached to
the oil lter ❷.
(Cautions) Be careful that a lubrication pipe and so on are not
damaged at the time of maintenance of a lter.
○ If there is clogging in the oil lter ❶,
smooth lubrication cannot be main-
tained from the lubrication hole.

JUKI DDL-8000A Specifications

General

Stitch Type	Lockstitch
Motor Type	Direct-drive motor
Thread Trimmer	Automatic
Max. Stitch Length	5mm
Needle Bar Stroke	30.7mm
Lift of the Presser Foot	By hand: 5.5mm, By knee: 13mm
Control Panel	Digital
Lubrication	Automatic