– 14 –
6. THREADING THE PANEL THREAD GUIDE
DU-141H-7, DSU, LZH-1290-7
DSC
Pass needle thread
coming from the thread stand
through the hole in panel thread guide
.
[DU-141H-7, DSU, DSC, LZH-1290-7]
7. ONE-TOUCH UTILITY MANUAL REVERSE FEED STITCHING
(1) How to operate
1) The moment switch
is pressed, the machine
feeds the material in the reverse direction and
performs reverse feed stitching.
2) The machine performs reverse feed stitching as
long as the switch is held pressed.
3) The machine resumes normal feed stitching at
the moment when the switch is released.
(Caution) Do not strongly press or strike the switch.
The switch may be damaged.
(2) Position of the switch
1) Approximately position the switch so that you can
operate it with ease.
2) Loosen screws
and adjust the position of the
switch by moving it up or down.
8. FRONT TIE STITCHING
In the case where stitch skipping occurs at the start
of sewing when performing single tie stitching ("V” tie
stitching), perform 1 to 2 stitches of normal feed at
the start of sewing.
Normal feed
To Next Page
Loading...
