To Next Page

To Previous Page

1004.GB

C 6

4 Commissioning

4.1 Moving the truck without a battery

This operation must only be performed by suitably trained maintenance personnel.

This operation is forbidden on slopes and inclines (no brakes).

See also chapter E, “Recovering the truck from a narrow aisle / Moving the truck

without a battery”.

4.2 Installing and removing the mast

This operation must only be performed by the manufacturer or a customer service

team authorised by the manufacturer.

5 Starting the truck for the first time

Operate the truck only with battery current. Rectified AC current will damage the

electronic components. The battery leads (tow cable) must be less than 6m long.

To prepare the truck after delivery or after transport, proceed as follows:

– Install and charge the battery if necessary (see Chapter D, Sections 4 and 3).

– Commission the truck as per instructions (See Chapter E, Section 3).

With the EKS 410/513/515k/515 a tipover retaining device (30) is fitted, depending on

the tipover test. When a tipover retaining device is used, an X (29) is engraved on the

truck chassis on the right hand side of the battery compartment, after the serial

number.

Before operating, check the trucks to ensure the tilt safety devices (30) are present

(if required).

Check that all safety devices are present and operational.