NOTE: When there is a double-bit ECC error in a network processor’s
memory, the Channelized OC3/STM1 (Multi-Rate) Circuit Emulation MIC
with SFP or Channelized E1/T1 Circuit Emulation MIC is switched to the
offline state.
user@host> show chassis fpc pic-status
Slot 1 Online MPC Type 2 3D Q
PIC 0 Offline 1xCOC12/4xCOC3 CH-CE- ECC error detected
lcc number—(TX Matrix router and TX Matrix Plus router only) (Optional) Line-card chassis
number.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
Required Privilege
Level
view
Related
Documentation
request chassis fpc•
• show chassis fpc-feb-connectivity
• show chassis fabric fpcs on page 116
• Configuring the Junos OS to Resynchronize FPC Sequence Numbers with Active FPCs
when an FPC Comes Online
• MX960 Flexible PIC Concentrator Description
• ACX2000 and ACX2100 Routers Hardware and CLI Terminology Mapping
• enhanced-mode
List of Sample Output show chassis fpc (EX6210 Switch) on page 170
show chassis fpc (M10 Router) on page 170
show chassis fpc (M20 Router) on page 170
show chassis fpc detail (M Series Routers) on page 170
show chassis fpc detail (MX80 Router) on page 171
show chassis fpc (MX104 Router) on page 171
show chassis fpc detail (MX104 Router) on page 171
show chassis fpc pic-status (MX104 Router) on page 172
165Copyright © 2016, Juniper Networks, Inc.
Chapter 13: Operational Commands: Packet Forwarding Engine Components
To Next Page
