•
Power off the device (see “Powering Off the PTX1000” on page 94).
•
Ensure that you have disconnected any cables or wires attached to the PTX1000 (see “Disconnecting a
Fiber-Optic Cable from the PTX1000” on page 108).
Ensure that you have the following parts and tools available:
•
Either a mechanical lift or two persons to support the weight of the PTX1000. An additional person is
needed to remove the screws securing the router to the rack.
•
Screwdriver appropriate for your rack-mounting screws.
To remove a PTX1000 from a rack:
1. Perform one of the following steps:
•
Position a mechanical lift under the PTX1000. Use the screwdriver to remove the front-mounting
screws that attach the router to the rack.
•
Have two persons support the weight of the PTX1000 while another person uses the screwdriver
to remove the front-mounting screws that attach the router to the rack.
2. Remove the PTX1000 from the rack.
3. Use the screwdriver to remove the mounting screws that attach the rear-mounting blades to the rear
of the rack.
4. Place the removed screws and rear-mounting blades in a labeled bag. You will need them when you
reinstall the chassis.
5. Transport the PTX1000 to your desired new location.
RELATED DOCUMENTATION
Mounting the PTX1000 in a Rack | 76
112
To Next Page
Loading...
