Juniper SRX5400 - Page 25

Use of third-party opcal modules with high-power consumpon (for example,
coherent ZR or ZR+) can potenally cause thermal damage to or reduce the lifespan of
the host equipment. Any damage to the host equipment due to the use of third-party
opcal modules or cables is the users’ responsibility. Juniper Networks will accept no
liability for any damage caused due to such use.
• Fabric interfaces
• One Gigabit Ethernet switch that provides control connecvity to the Roung Engine.
• Two interfaces from the SCBs that enable the boards to be powered on and controlled.
• Physical SPC connectors
• Midplane connectors and power circuitry.
• Processor subsystem, which includes a 2.3-GHz CPU, system controller, and two 128 GB solid state-
drives (SSDs).
• LEDs on the faceplate that indicate the SPC and SPU status.
Descripon SPC with two SPUs of 256 GB memory.
Soware release
• Junos OS Release 18.2R1-S1
Cables and
connectors
HA0 and HA1 SFP+ ports for control links in chassis cluster conguraons.
Supported transceivers:
• 10GBASE–LR: transceiver model number SRX-SFP-10GE-LR
• 10GBASE–SR: transceiver model number SRX-SFP-10GE-SR
Controls None
Supported Slots
• SRX5400–Any slot, except the boom slot 0 which is reserved for SCB/RE.
• SRX5600–Any slot, except the boom slots 0 or 1 which are reserved for SCB/RE.
• SRX5800–Any slot, except slot 11, and the slots 0 or 1 which are reserved for SCB/RE.
21