For more information, see the RingMaster and MSS guides at: RingMaster and MSS Guides.
Use the following hardware from Juniper Networks to connect the access point and make
it operational:
•
WLC2 Wireless LAN Controller
•
WLC200 Wireless LAN Controller
•
WLC216 Wireless LAN Controller
•
WLC8 Wireless LAN Controller
•
WLC800 Wireless LAN Controller
•
WLC880 Wireless LAN Controller
•
WLC2800 Wireless LAN Controller
The WLA532 access point can be powered up and operational within 3 minutes and
supports all features of RingMaster and Mobility System Software (MSS).
Related
Documentation
General Safety Standards and Agencies for Access Points on page 19•
• Installing the WLA532 Access Point on a Suspended Ceiling Rail on page 33
• Installing the WLA532 Access Point on the Wall Using Hardware Kits on page 36
MAC Address Information for WLA Series Access Points
Each WLA Series access point is assigned a unique block of 64 MAC addresses. Each
radio has 32 MAC addresses and supports up to 32 service set identifiers (SSIDs), with
one MAC address assigned to each SSID as a basic service set identification (BSSID).
The access point MAC address block is listed on a label on the back of the access point.
If the access point is already deployed and running on the network, you can display MAC
address assignments by using the show ap status command in the Mobility System
Software CLI.
All MAC addresses for an access point are assigned based on the base MAC address of
the access point as described in Table 1 on page 5.
Table 1: MAC Address Information for WLA Series Access Points
DescriptionMAC Address Type
The access point has a base MAC address. All other addresses are assigned based on this
address
Access point base MAC address
•
The MAC address of Ethernet port 1 is the same as the access point base MAC address
•
The MAC address of Ethernet port 2, if there is an Ethernet port 2 on the access point,
is the same as the access point base MAC address + 1. (Not applicable to the WLA532
access point)
Ethernet port MAC addresses
5Copyright © 2012, Juniper Networks, Inc.
Chapter 1: WLA532 Access Point Overview
To Next Page
Loading...
