•
Wall-mount bracket–See Figure 13 on page 38 and item a in Figure 12 on page 37
(provided in the WLA-BRKT-WALL kit)
NOTE: The wall-mount bracket extends the access point 1.5 inches from
the wall to accommodate the Ethernet cable bend radius.
Figure 13: Wall-Mount Bracket Dimensions-–WLA-BRKT-WALL
128.10mm
83.34mm
72.54mm
15.57mm
g060023
The cable opening can be installed on the
top or bottom depending on the mounting
orientation of the bracket.
Side cable opening
27.98mm
Wall bracket mount
hole diameter: 3.96mm
•
Two flat-tip, flat-head screws–See item b in Figure 12 on page 37 (provided in the
WLA-BRKT-WALL kit)
•
Faceplate–See item c in Figure 12 on page 37 (provided in the WLA-BRKT-WALL kit)
•
Flat-head screwdriver (not provided)
•
Category 5 cable, installed (not provided)
•
Two M3 or 6-32 wall anchors (not provided)
•
Wall-mount template (part number 530-043682, provided in the WLA-BRKT-WALL
kit)
•
(Optional) Security kit, which includes a security tool and a security screw (The kit is
not provided; you can order it separately at
https://www.juniper.net/customers/support/.)
Copyright © 2012, Juniper Networks, Inc.38
WLA532 Access Point Hardware Documentation
To Next Page
Loading...
