Juniper WLA532 - Table 2: Status Leds on WLA532 Access Points

Table 2: Status LEDs on WLA532 Access Points
Status and DescriptionColorLabel
On steadily when the:
•
Access point has booted and received
a valid configuration
•
Management link with a wireless LAN
controller (WLC) is operational
•
One or both radios are enabled or are
in sentry mode
Green, solidSTAT
The access point is waiting to receive
boot instructions and a configuration file
from a controller or switch
Yellow, solid
The access point is booting and is
receiving a configuration file from a
controller, or a switch, or is waiting for a
radio to be enabled or placed in sentry
mode
Green and yellow, alternating
A client is associated with the radioGreen, solidRadios (11 AN and 11 BGN)
Associated client is sending or receiving
traffic
Green, flashing
Nonassociated client is sending or
receiving traffic
Yellow, flashing
Radio is unable to transmit data; the
problem can occur due to any of the
following:
•
Excessive interference is preventing
the sending of beacons
•
The radio has failed
Green and yellow, alternating
Radio is disabled or is in sentry modeYellow, solid
No radio is present, or if a radio is present
and enabled, no clients are associated
with the radio and there is no traffic
Unlit
Related
Documentation
• Ethernet Connections for WLA532 Access Points on page 9
• Requirements and Specifications for 2.4-GHz Radios on WLA532 Access Points on
page 25
• Requirements and Specifications for 5-GHz Radios on WLA532 Access Points on
page 25
• Installing the WLA532 Access Point on a Suspended Ceiling Rail on page 33
• Installing the WLA532 Access Point on the Wall Using Hardware Kits on page 36
7Copyright © 2012, Juniper Networks, Inc.
Chapter 1: WLA532 Access Point Overview