Juniper WLA532 - Verifying the Health of the Access Point; Verifying the Health of WLA Series Access Points Using LEDs

This topic covers installation of the WLA532 access point on three different wall-mount
kits:
•
WLA-BRKT-WALL Wall-Mount Kit (Faceplate and Wall-Mount Bracket Standard
Hardware) on page 37
•
WLA-GNGWLBX-ADP-EU Kit (European Faceplate Standard Hardware) on page 43
•
WLA-GNGWLBX-ADP-NA Kit (North American Faceplate Standard
Hardware) on page 44
WLA-BRKT-WALL Wall-Mount Kit (Faceplate and Wall-Mount Bracket Standard Hardware)
You can purchase the wall-mount WLA-BRKT-WALL kit (see Figure 12 on page 37) that
includes a wall-mount bracket, a standard faceplate and two flat-tip, flat-head screws
at https://www.juniper.net/customers/support/.
Figure 12: WLA-BRKT-WALL Kit (Wall-Mount Bracket Kit Hardware)
Ensure that you have the following parts and tools available to install the access point
using the WLA-BRKT-WALL kit:
37Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point