have locked. Be sure the bracket has locked securely onto the rail by gently pulling
down on the bracket before installing the access point.
Figure 8: Locking the Bracket Clips Over the Rail
7. Plug in the Category 5 cable that extends from the ceiling into the access point.
8. Align the access point with the bracket and press forward (see Figure 9 on page 35)
until the access point clicks into place. Be sure the access point is seated correctly in
the bracket by gently pulling down on the access point.
Figure 9: Aligning the Access Point with the Ceiling Bracket
9. If the access point is not properly secured, press on the release button on the top of
the bracket to unlock the access point (see Figure 10 on page 36). Realign the access
point, making sure the cable is still connected, and push in until the access point clicks
securely into place.
35Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point
To Next Page
Loading...
