Table 4: Radio Specifications for the WLA532 Access Point (continued)
DescriptionSpecification
2.4-GHz to 5-GHz based on country regulationsFrequency band
Based on the country of operation specified by the system administratorOperating channels
802.11n rates: MCS 0 through MCS 23Association rates
Orthogonal Frequency Division Multiplexing (OFDM) for IEEE 802.11a/g/n
Quadrature Amplitude Modulation (QAM16 and QAM 64) for IEEE 802.11a/g/n
Direct-Sequence Spread Spectrum (DSSS) modulation for IEEE 802.11b
Modulation
18 dBm transmit power per chain (200 mW, combined 3-stream output power) at both
HT20 and HT40 MCS0 data rate for both 2.4-GHz and 5-GHz
12 dBm transmit power per chain (50 mW, combined 3-stream output power) at both HT20
and HT40 MCS23 rate for both 2.4-GHz and 5-GHz
Transmit power
Table 5: 2.4-GHz Radio Receive Sensitivities
2.4-GHz Radio Receive Sensitivities (in dBm)
HT-20Legacy "g"Legacy "b"
MCS23MCS16MCS15MCS8MCS7MCS054
Mbps
6 Mbps11 Mbps1 Mbps
-75-94-77-94-79-95-83-95-92-99
Table 6: 5-GHz Radio Receive Sensitivities
5-GHz Radio Receive Sensitivities (in dBm)
HT-40HT-20Legacy "a"
MCS23MCS16MCS15MCS8MCS7MCS0MCS23MCS16MCS15MCS8MCS7MCS054
Mbps
6
Mbps
-72-91-74-91-75-92-74-94-77-95-79-96-83-96
Related
Documentation
• WLA532 Access Point Hardware Overview on page 3
15Copyright © 2012, Juniper Networks, Inc.
Chapter 3: Technical and Mechanical Specifications
To Next Page
Loading...
