Table 3: Mechanical and Compliance Specification for WLA532 (continued)
DescriptionSpecification
FCC CFR 47, Part 2 Frequency allocations and general treaty
matters, General rules
FCC CFR 47, Part 15 Radio Frequency Devices
EN 300 328 EMC and Radio Spectrum Matters 2.4-GHz ISM band
EN 301 489-1 EMC and Radio Spectrum Matters: Common Technical
requirements
EN 301 489-17 EMC and Radio Spectrum Matters: 2.4-GHz wideband
and 5-GHz RLAN
EN 301 893 Broadband Radio Access Networks 5-GHz RLAN
R&TTE Directive 1995/5/EC
Various Country Specific Radio Regulations
Radio compliance
Wi-Fi Protected Access (WPA/WPA2)
Advanced Encryption Standard (AES)
40-bit/104-bit Wired-Equivalent Privacy (WEP)
Encryption
Power-save mode supported
Transmit power control in 1-dBm increments
Supports up to 50 clients per radio
NOTE: This number may vary with the state of RF environment and
types of clients.
Supports Dynamic Frequency Selection
General
Radio Specifications
The radio specifications for the WLA532 access point are listed in Table 4 on page 14.
Table 5 on page 15 and Table 6 on page 15 shows the receive sensitivity numbers for
WLA532 access point.
Table 4: Radio Specifications for the WLA532 Access Point
DescriptionSpecification
Integrated diversity omnidirectional
Internal 3X3 multiple input multiple output (MIMO)
Antenna type
Internal: 3 dBi (2.4-GHz)
Internal: 5 dBi (5-GHz)
Antenna gain
Copyright © 2012, Juniper Networks, Inc.14
WLA532 Access Point Hardware Documentation
To Next Page
Loading...
