To install the access point on the wall:
1. Use the provided WLA532 wall-mount template to determine your anchor mounting
location (see Figure 14 on page 39) and install the wall anchors (not included in the
WLA-BRKT-WALL kit).
Figure 14: Use the Provided Template to Install Wall Anchors
2. Hold the wall-mount bracket centered over the wall anchors and pull the installed
Category 5 cable through the wall-mount bracket (see Figure 15 on page 40).
39Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point
To Next Page
Loading...
