Juniper WLA532 - Verifying the Health of the Access Point; Verifying the Health of WLA Series Access Points Using Leds

CHAPTER 8
Verifying the Health of the Access Point
•
Verifying the Health of WLA Series Access Points Using LEDs on page 49
Verifying the Health of WLA Series Access Points Using LEDs
After you install the WLA Series access point and enable the Power over Ethernet (PoE)
on the Ethernet cable connected to the access point, you can verify the access point
status by observing the health LED. The health or STAT LED indicates whether the access
point is operational.
•
If the LED is green and glowing steadily, the access point has booted successfully by
the wireless LAN controller (WLC) and is operational.
•
If the LED is not steadily glowing green, contact the system administrator for the WLC.
Related
Documentation
• Status LEDs on WLA532 Access Points on page 6
49Copyright © 2012, Juniper Networks, Inc.