Juniper WLA532 - Figure 15: Pull the Category 5 Cable through the Wall Bracket; Figure 16: Use M3 or 6-32 Wall Anchors to Secure the Bracket to Anchors

Figure 15: Pull the Category 5 Cable Through the Wall Bracket
3. Install the bracket to the anchors using M3 or 6-32 wall anchors (see Figure 16 on
page 40).
Figure 16: Use M3 or 6-32 Wall Anchors to Secure the Bracket to Anchors
4. Align the faceplate with the installed wall-mount bracket and secure the faceplate
using the two provided flat-tip screws and the screwdriver (see Figure 17 on page 41).
Copyright © 2012, Juniper Networks, Inc.40
WLA532 Access Point Hardware Documentation