c. Remove the mounting template and the material you cut from the ceiling tile.
3. Run the Category 5 cable from the ceiling through the hole in the ceiling tile.
4. Ensure the snaps on the top of the ceiling-mount bracket are open so that the clips
can fully extend to fit around the ceiling rail. The bracket is shipped in an open position
so that it is ready to be clipped over a ceiling rail (see Figure 6 on page 34).
Figure 6: Opening the Ceiling Bracket Clips
5. If the bracket is closed, open the snaps by pressing in and up with your thumbs on
both sides of the snaps on the bottom of the bracket (see Figure 7 on page 34) until
it is fully open.
Figure 7: Opening the Ceiling Bracket Snaps
6. With the bracket clips fully extended, align the clips with the rail and hook the clips
around the top sides of the rail. Push in on the sides of the bracket until the clips lock
over the rail (see Figure 8 on page 35). Listen for a click that indicates that the clips
Copyright © 2012, Juniper Networks, Inc.34
WLA532 Access Point Hardware Documentation
To Next Page
Loading...
