21
GETTING
READY
Switching On and Switching Off
Switching On
1
Slide the POWER switch to
the right.
• Slide the switch in the direction of
the arrow and then release it after
about one second.
• The direction indicator flashes and
rotates.
Switching Off
1
Slide the POWER switch to
the right.
• Slide the switch in the direction of
the arrow and then release.
! CAUTIONS
• Remove the battery if the camera will not be used for a long period.
• Do not put the camera in a bag or pocket while it is switched on.
Auto Power Off Function
If the camera is not used in any way for two minutes or more, the Auto Power Off
function switches the camera off. This is to prevent battery depletion and to avoid
excessive power usage when the camera is connected to the AC power adapter.
• The Auto Power Off function does not operate during automatic playback (aP.45) or
in PC-mode (aP.79).
• To disable the Auto Power Off function, hold down the [MENU/EXE] button as you
switch the camera on. To re-enable the Auto Power Off function, switching the
camera off and then on again. If you operate the camera in live video mode (the
video image shown before a picture is taken) or continuous playback mode for a
long period, the camera body may become quite warm. This is not a fault.
• Note that if the camera has been left switched on but unused for 2 minutes or more,
the flash may not operate when a photograph is taken and you may not obtain the
correct image.
To Next Page
Loading...
Need help?
General
