91
OTHER
ExplanationStatusWarning Displayed
Warning Displays
• The table below lists the warnings that are displayed on the LCD monitor.
• If “
E” appears in the No. of available shots field on the LCD panel and the
viewfinder lamp flashes red, or “SYSTEM ERROR” appears on the LCD
monitor, switch the camera off and leave it for about one hour before
switching it on again. If the camera still fails to operate normally, contact your
JVC dealer or your local authorised JVC service facility and request repairs.
@
Flashing
@
Flashing
The SmartMedia is write-protected (
aP.22).
@
Flashing
@
Flashing
Flashing
The SmartMedia is not formatted (
aP.59).
No SmartMedia is loaded, or it is loaded
incorrectly (
aP.24).
All the frames on the SmartMedia contain
recorded images.
The camera battery is low on charge
(
aP.19).
@
Flashing
The SmartMedia is damaged.
The SmartMedia format is incorrect.
An attempt was made to play back
incorrectly recorded data.
An attempt was made to play back a frame
not recorded on this camera.
The SmartMedia was removed during
recording, playback, erasing or copying.
@
Flashing
@
Flashing
A protected frame was erased (aP.57).
@
Flashing
Flashing The flash is set to Suppressed Flash mode
or Forced Flash mode, so the shutter speed
is slow and there is a strong likelihood of
camera shake (
aP.41).
@
Flashing
The AF (auto focus) cannot operate
properly because there is very little contrast
in the subject (
aP.27).
To Next Page
Loading...
Need help?
General
