SCAN EXAM 19
3. Using the system
3. Hold the protective cover and IP so that
the white side of the protective cover is
on the right. The metal disk on the IP will
also be on the right.
Insert the protective cover and IP into the
unit door.
A magnet will hold the IP in the correct
position.
4. Slide the protective cover off of the IP,
and leave the IP in position half way in
the unit door.
As soon as the protective cover is re-
moved the unit detects that the IP is in
the unit door and will switch from the
standby state to the ready state (ready
to use) and automatically slide the IP into
the unit.
CAUTION:
If the IP does not slide into the unit after
the protective cover has been removed,
the IP is misaligned or has been placed in
the unit the wrong way round. Reposition
the IP and insert it into the unit again.
If after repositioning the IP it still does not
slide into the unit press the Start key to
manually switch the unit from the standby
to the ready state and the IP will then
slide into the unit when the protective
cover is removed.
To Next Page
Loading...
Need help?
General
