B-6 SCAN EXAM
B. Installation and setup
B.2.3 Using Express Share
By default the unit is intended to be operated
from a single workstation. This is a normal
set up for personal use, for an X-ray room
install and for “fi lm-like” operation where the
scanner and a PC form a “digital development
station”. The images can still be accessed,
viewed and manipulated from multiple
workstations in the network as long as these
workstation have an access to the server-
software.
For a shared use it is also possible to
operate the unit from multiple PC. To
manage the capture from multiple PC is
done using a feature called Express Share.
Each workstation will be assigned a unique
identifi er which is visible on the display of
the unit when this workstation is operating
the unit. If Express Share is used the
feature must be activated in all workstations
operating the unit.
In the Express Share mode there is an auto-
release time out when the unit has been idle
for a predefi ned time.
See the instructions in chapter B3 to enable
the Express Share. The procedure must be
repeated at all workstations operating the
unit.
If your system does not allow the direct
connection