B-16 SCAN EXAM
B. Installation and setup
- After each patient: UV disinfection
is automatically carried out after the
patient card is closed. The remaining
UV disinfection time appears on the unit
display.
- Disabled: Switched off UV disinfection so
that it does not operate. Also, all warning
messages related to UV lamp status are
discarded.
NOTICE:
If any automatic UV disinfection mode is
selected a UV disinfection cycle will ALWAYS
be automatically carried out when the unit is
switched off and prior to fi nal unit shutdown
During this shutdown UV disinfection cycle
the remaining disinfection time will appear on
the unit display. If you wish to stop the UV
shutdown disinfection cycle:
- Press and hold down (4 seconds)
the power on / off key, the unit will
immediately shutdown.
or
- Press and hold down (4 seconds) the start
key, the unit will return to the normal
operation mode.
Manual UV disinfection control
Click the Disinfect key to manually start and
stop (Cancel) UV disinfection. The elapsed
disinfection time will appear on the unit
display.
UV disinfection will automatically stop after
15 minutes.
If you wish to stop manual UV disinfection
before the complete cycle is fi nished, press
the Manual UV disinfection control /
Cancel key or press and hold down (4
seconds) the start key.