Kaye LTR -90 - 6.1.6 Programs (Automated Tests); 6.1.6 a Run a Program; 6.1.6 b Stop a Program

Chapter 6. Calibrator Operation
32 Kaye LTR -90 Operating Manual
6.1.6 Programs (Automated Tests)
The Program menu (PROG MENU) supplies access to the automated and manual Program selections (see “Program
Setup” on page 33). A Program is an automated test that can be configured and run on an instrument.
6.1.6a Run a Program
To run a Program:
1. Push .
2. Push
3. Push .
4. Push to change the
TEST STATUS to RUN.
5. Push to save.
6. Push twice to leave programming.
6.1.6b Stop a Program
To stop a Program:
1. Push .
2. Push .
3. Push .
4. Push to change the
TEST STATUS to OFF.
5. Push to save.
6. Push twice to leave programming.