Chapter 1. Product Overview
2 Kaye LTR -90 Operating Manual
1.1 Safety Information
WARNING! A Warning identifies conditions and procedures that are dangerous to the user.
CAUTION!
A Caution identifies conditions and procedures that can cause damage to the product or the
equipment under test.
See Table 1 below for a list of symbols used in this manual and on the Calibrator.
WARNING!
To prevent possible electrical shock, fire, or personal injury:
Read all safety Information before you use the Product.
Use the Product only as specified, or the protection supplied by the Product can be
compromised.
Use this Product indoors only.
Do not use the Product around explosive gas, vapor, or in damp or wet environments.
Do not use and disable the Product if it is damaged.
Use only the mains power cord and connector approved for the voltage and plug configuration
in your country and rated for the Product.
Replace the mains power cord if the insulation is damaged or if the insulation shows signs of
wear.
Table 1: Symbols
Symbol Description Symbol Description
Conforms to European
Union directives
Conforms to relevant North American Safety
Standards.
Risk of Danger. Important
information. See manual.
Conforms to relevant Australian EMC
requirements.
Earth ground Hazardous voltage
This product complies with the WEEE Directive (2002/96/EC) marking requirements.
The affixed label indicates that you must not discard this electrical/electronic product in
domestic household waste. Product Category: With reference to the equipment types in
the WEEE Directive Annex I, this product is classed as category 9 “Monitoring and
Control Instrumentation” product. Do not dispose of this product as unsorted municipal
waste.
To Next Page
Loading...
