Kaye LTR -90 Operating Manual 3
Chapter 1. Product Overview
WARNING! Make sure the ground conductor in the mains power cord is connected to a protective
earth ground. Disruption of the protective earth could put voltage on the chassis that could
cause death.
Do not put the Product where access to the mains power cord is blocked.
Use caution when you install and remove probes and inserts from the Product. They can be hot.
Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V dc.
Do not apply more than the rated voltage, between the terminals or between each terminal and
earth ground.
Do not touch the well access surface of the instrument.
Do not turn off the product at block temperatures higher than 100°C. Select a SETPOINT less
than 100°C and let the instrument cool before turning it off.
Use the correct terminals, function, and range for measurements.
Do not use test leads if they are damaged. Examine the test leads for damaged insulation,
exposed metal, or if the wear indicator shows. Check test lead continuity.
Do not touch the probes to a voltage source when the test leads are connected to the current
terminals.
Keep fingers behind the finger guards on the probes.
Do not exceed the Measurement Category (CAT) rating of the lowest rated individual component
of a Product, probe, or accessory.
To Next Page
Loading...
