KEB COMBIVERT F6 - 2.3 Product features

23
PRODUCT DESCRIPTION
2.3 Product features
These instructions for use describe the power circuits of the following units:
Unit type: Drive converter
Series: COMBIVERT F5 / F6
Power range: 200…315 kW as Single Drive 400…560 kW as Master / Slave
system
630…900 kW
as Master / Slave / Slave system
Housing: P
The COMBIVERT F5 / F6 is characterized by the following features:
• Operation of three-phase asynchronous motors and three-phase synchronous
motors
• Operating modes open-loop or closed-loop with and without speed feedback
• Fieldbus interface F5 is realized by operator
• Fieldbus interface F6 supports the following systems directly: EtherCAT, VARAN
or CAN
• System-overlapping operating concept
• Wide operating temperature range
• Low switching losses due to IGBT - power unit
• Low noise development due to high switching frequencies
• Different heat sink concepts
• Air cooler as built-in version
• Air cooler as push-through version
• Liquid cooler as built-in version
• Liquid cooler as push-through version
• Liquid cooler with stainless steel tubes as built-in version
• Easily replaceable fans
• Depending on the operating mode, the torque limits and s-curves are adjustable
(to protect the gear box)
• General protective functions of the COMBIVERT series against overcurrent, over-
voltage and overtemperature
• Analog and digital inputs and outputs
• Potential-free relay output
• Brake control and supply
• Motor protection by I²t
• KTY, PT100 and PTC input
• Diagnostic interface