SoftStep advanCed editor
26
SoftStep3
y live
Outputs the amount of bottom-to-top pressure (y-axis) currently being applied to the key� The value will return
to center (64) when the key is released� Range: 0-127 (bottom to top)
preSSUre latCh
Outputs the amount of pressure being applied to the key, but the value latches and stays wherever it is when
the key is released� Range: 0-127
x latCh
A latching version of the X Live source — the value stays where it is when the key is released� Range: 0-127
y latCh
A latching version of the Y Live source — the value stays where it is when the key is released� Range: 0-127
x inCreMent
Applying pressure left-right will increase or decrease the value at a rate determined by the “x inc speed” set in
the “Keys” tab of the “Settings” window� Range: 0-127
y inCreMent
Applying pressure up-down will increase or decrease the value at a rate determined by the “y inc speed” set in
the “Keys” tab of the “Settings” window� Range: 0-127
foot on
Outputs a 127 when the key is pressed and a 0 when the key is released�
foot off
The inverse of Foot On — outputs a 0 when the key is pressed and a 127 when the key is released�
randoM
Outputs a continuous stream of random values when pressure is applied to the key�
randoM SinGleS
Outputs a single random value when you press on the key�
dbl triG
Two quick presses of the key will output a value of 127 followed by a value of 0 100ms later�
To Next Page
Loading...