Keith McMillen Instruments SoftStep3 - Page 27

SoftStep advanCed editor
27
SoftStep3
lonG triG
Pressing and holding the key for 1 second will output a value of 127 followed by a value of 0 100ms later�
top (hoSted Mode only)
Outputs a 127 when the top half of the key is pressed and a 0 when the key is released�
bottoM (hoSted Mode only)
Outputs a 127 when the bottom half of the key is pressed and a 0 when the key is released�
faSt triG (hoSted Mode only)
Pressing the key immediately outputs a 127 followed by a 0 (100ms later)�
off triG (hoSted Mode only)
Outputs a 127 followed by a 0 (100ms later) when the key is released�
faSt triG latCh (hoSted Mode only)
Immediately outputs a 127 when the key is pressed� Does not go back to 0�
dbl triG latCh (hoSted Mode only)
Two quick presses of the key will output a 127� Does not go back to 0�
lonG triG latCh (hoSted Mode only)
Pressing and holding the key for 1 second will output a 127� Does not go back to 0�
pedal
If an expression pedal is connected, this source will output the current value coming from the pedal�
init (Standalone Mode only)
Outputs a 127 whenever the current preset is loaded. Useful for initializing values whenever a specic preset
is loaded. Use the min and max options (or offset) in the modlines to send a specic value.
nav yx10 & key
Works in tandem with the Nav Pad� The Nav Pad must also be in Program Change mode or using the Nav Y
Decade source�
The Nav Pad’s current counter value is multiplied by 10 to get a “decade” — e�g� 20s, 30s, 40s, etc�, then the
key number (this source is placed on) is added to the value when pressed�