Kemppi MasterMig 353 User Manual

MasterMig 353, 355
Operating manual- EN
2.6 Installing remote control (optional)
Remote controls are optional. To enable remote operation, connect the remote control device to the MasterMig welding
equipment. The remote control mode can be set and adjusted in the control panel settings ("Control panel: System set-
tings" on page42).
Remote control HR43/HR40
1. Connect the remote control cable to the control cable connector.
2. Adjust the remote control parameters in the control panel settings.
© Kemppi
19
1921960 / 2217

Kemppi MasterMig 353 Specifications

General

Brand	Kemppi
Model	MasterMig 353
Category	Welding System
Language	English