Kemppi MasterMig 353 - Equipment Description

MasterMig 353, 355
Operating manual- EN
1.1 Equipment description
MasterMig device models (350 A)
• MasterMig 353 G
>> Generator-compatible
>> Standard device with automatic 1-MIG process
• MasterMig 353 GM
>> Generator-compatible and multi-voltage
>> Standard device with automatic 1-MIG process
• MasterMig 355 G
>> Generator-compatible
>> Pulse device with automatic 1-MIG and pulse processes. Advanced MAX processes as optional.
• MasterMig 355 GM
>> Generator-compatible and multi-voltage
>> Pulse device with automatic 1-MIG and pulse processes. Advanced MAX processes as optional.
All MasterMig device models have a 4-roll wire feed mechanism with the maximum wire spool diameter of 300 mm.
For the MasterMig device part descriptions, refer to "MasterMig device" on the next page.
MasterMig control panels
• Color LCD display
MasterMig cooling units
• MasterMig Cooler
• MasterMig Cooler M (multi-voltage).
For the cooling unit part descriptions, refer to "MasterMig Cooler cooling unit (optional)" on page10.
MIG welding guns
• Flexlite GX welding guns with euro connector.
For more information on the Flexlite GX welding guns, refer to Kemppi Userdoc.
Subfeeders
Subfeeder support can be added with a separate installation kit (contact your Kemppi dealer / service workshop for
more information).
• SuperSnake GTX subfeeder.
For more information on the SuperSnake GTX subfeeder, refer to Kemppi Userdoc.
Optional accessories
• 4-wheel carts
• 2-wheel carts
• Remote control HR40 (2-knob control)
• Remote control HR43 (1-knob control)
• Power source air filter
• Wire feed cabinet heater.
For more information on optional accessories, contact your local Kemppi dealer.
© Kemppi
6
1921960 / 2217