Kemppi MasterMig 353 User Manual

MasterMig 353, 355
Operating manual- EN
2.7 Installing and changing wire
Always ensure that the feed rolls are suitable for the filler wire (diameter and material) in question. For more information,
refer to "Wire feeder consumables" on page70.
Install the welding gun to the MasterMig device before installing the wire spool.
When changing the wire spool, remove the remaining filler wire from the welding gun and wire feed mechanism
before removing the wire spool.
To remove the wire spool:
1. Open the wire feed cabinet hatch.
2. Loosen and remove the spool fastener and remove the wire spool.
To install a new wire spool:
1. Insert the wire spool onto the spool hub. Secure the wire spool in place by inserting and tightening the spool
fastener.
Ensure that the wire spool is facing the right direction, the filler wire running from the bottom of the spool to the
feed rolls.
© Kemppi
20
1921960 / 2217

Kemppi MasterMig 353 Specifications

General

Brand	Kemppi
Model	MasterMig 353
Category	Welding System
Language	English