MasterMig 353, 355
Operating manual- EN
2.4 Connecting welding gun
MasterMig is designed to be used with the Kemppi Flexlite GX welding guns. For the Flexlite GX operating instructions,
refer to userdoc.kemppi.com.
Always check that the wire liner, contact tip and gas nozzle are suitable for the job.
1. Push the welding gun connector into the euro connector and hand-tighten the collar.
2. If your setup includes a water-cooled gun, connect the cooling liquid hoses to the cooling unit. The hoses are color-
coded.
3. Install and load the filler wire as described in "Installing and changing wire" on page20.
4. Check the gas flow. Refer to "Installing gas bottle and testing gas flow" on page28 for more information.
© Kemppi
17
1921960 / 2217
To Next Page
Loading...
Need help?
General
