Kemppi MasterMig 353 User Manual

MasterMig 353, 355
Operating manual- EN
2. If needed, adjust the spool brake by turning the spool brake tightening knob in the center of the spool hub.
To install the filler wire:
1. Release the filler wire end from the spool and cut off any deformed section so that the end is straight.
Ensure that the filler wire does not spill from the spool when it is released.
2. File the tip of the filler wire smooth.
Sharp edges on the filler wire tip may damage the wire liner.
3. Release the pressure arms to move the feed rolls apart.
© Kemppi
21
1921960 / 2217

Kemppi MasterMig 353 Specifications

General

Brand	Kemppi
Model	MasterMig 353
Category	Welding System
Language	English