X8 MIG WELDER 2.4 Operation
Ensure that the surface contact to the table is clean of metal oxide and paint and that the clamp is firmly
secured.
2.4.2.1 Filling cooler
Fill the cooler with 20-40 % coolant solution, for example, Kemppi cooling liquid.
Proceed as follows:
1.
Pull the front panel latch and open the front panel of the power source.
2.
Unscrew the lid on top of the cooler.
3.
Fill the cooler with coolant solution. Do not fill over the line.
OPERATING MANUAL | EN 103
©
KEMPPI | 2018-09-28
To Next Page
Loading...
Need help?
General
