Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
Filler wire material Feed roll profile Filler wire diameter (mm) Adjustment (x100N)
Fe/Ss solid V-groove 0.8−1.0
≥ 1.2
1.5−2.0
2.0−2.5
Metal and flux cored V-groove, knurled ≥ 1.2 1.0−2.0
Self-shielded V-groove, knurled ≥ 1.6 2.0−3.0
Aluminium U-groove 1.0
1.2
1.4
≥ 1.6
0.5 1.0
1.0−1.5
1.5−2.0
2.0−2.5
Caution:
Excessive pressure flattens the filler wire and may damage coated or cored filler wires. Excessive
pressure also unnecessarily wears the feed rolls and increases gearbox load.
18.
Press Wire inch to drive the filler wire to the welding gun's contact tip. To speed up the wire feed speed,
turn the left control knob on the control panel.
Note:
The control panel shows how much the filler wire has run.
OPERATING MANUAL | EN 47
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English