Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
Finalize the installation:
19.
Select the shielding gas and attach the gas cylinder to the wire feeder.
20.
Press Gas test to flush the former shielding gas from the system.
Note:
You can also use this button to test that the gases flow through the system properly.
21.
Close the top cover.
Wire spools
X8 MIG Welder has three different wire spool hub options available for different wire spools:
A. Standard spool
B. Spool hub for the small wire spool
Attach the extension pieces to the standard spool halves.
C. Spool hub for the wire spool with a large center hole
All parts are delivered with the wire feeder.
Loosen and pull the spool halves to detach them.
OPERATING MANUAL | EN 48
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English