X8 MIG WELDER 2.3 Installation
Note:
X8 MIG Guns connect to X8 Wire Feeder with Kemppi Gun Adapter that enables, among other
things, accurate measurement of the actual arc voltage and the usage of the remote control.
Therefore, X8 MIG Guns are only compatible with X8 Wire Feeder.
5.
If your setup includes a water-cooled gun, connect the cooling hoses to the wire feeder. The coolant
inlet hose is marked with blue and the coolant outlet hose with red color.
6.
Dress the sharp filler wire tip before loading to improve wire loading and to lengthen consumables'
lifetime.
7.
Press the Wire inch button to load the filler wire.
OPERATING MANUAL | EN 60
©
KEMPPI | 2018-09-28
To Next Page
Loading...
Need help?
General
