Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
6.
Assemble the cone (1), seal (2) and sleeve (3) (supplied with the new liner) over the liner protruding from
the welding gun connector. Tighten the sleeve as tight as possible with a spanner.
1 2 3
7.
Cut the excessive liner leaving 1 - 2 mm. Use side cutting pliers for spiral liner and carpet knife for DL
Chili liner.
OPERATING MANUAL | EN 65
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English