Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
1. Lock the rotating plate to its position.
2. Adjust the length of the arm. Tighten the screws to lock to position.
3. Turn to adjust the tension of the counterbalance spring.
4. Turn to adjust the damping of the up and down movement.
Wire Feeder Cabinet Heater
The wire feeder cabinet heater prevents moisture from condensing inside the wire feeder cabinet so that the
wire spool stays dry.
Double Wire Feeder Rotating Plate
The double wire feeder rotating plate allows the use of two wire feeders on one power source.
OPERATING MANUAL | EN 82
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English