Kenwood K-521 - Page 70

70
K-521
Troubleshooting
Symptoms Solution Ref. page
CD
A CD does not play back
when loaded.
Load the disc correctly with the label side facing upward.
z
Clean the disc. (See <Care and Storage>.)
z
Allow any condensation to evaporate. (See <Beware of
z
condensation.)
26
73
73
No sound output Press the
z
[CD
E
] key.
Clean the disc. (See <Care and Storage>.)
z
26
73
Playback skips. Clean the disc. (See <Care and Storage>.)
z
73
Some audio fi les can't
play back.
The system will not play audio fi les that are corrupted.
z
Make sure the audio fi le is supported for playback on the
z
system.
23
Delay until playback
starts.
There may be a delay prior to playback if there are large
z
numbers of folders.
28
TAG information is not
displayed correctly.
Refer to <Supported Audio Files> to check which TAG
z
information can be displayed on this system.
23
Symptoms Solution Ref. page
iPod
The iPod cannot be at-
tached fi rmly.
Check to see whether the correct Dock adapter is used.
z
Then check to see whether the connector between the
iPod and the system is not damaged, and reconnect
them.
12
The iPod does not pro-
vide sound.
The iPod is not properly connected. Remove the iPod
z
from the system, and then connect it again.
12
The iPod cannot be
charged.
The iPod is not properly connected. Remove the iPod
z
from the system, and then connect it again.
12
Symptoms Solution Ref. page
USB
No sound output when
USB flash memory or a USB
audio player is connected.
Plug in the USB fl ash memory correctly.
z
Connect the USB cable correctly.
z
Check to make sure the USB audio player is turned on.
z
12
40
K-521EB60-5813-0801GVT0294-002A.indb70K-521EB60-5813-0801GVT0294-002A.indb70 09.10.264:32:02PM09.10.264:32:02PM