The information if the goods to be weighed are within the tolerance limits, can
additionally be given by an acoustic signal (menu item „ „ see chap. 13.2)
For tolerance control, also only one limit value can be set.
If both limit values are deleted, the tolerance control is deactivated.
12.2.1 Delete limit values:
When entering upper and lower threshold, press key and confirm with .
12.3 Store data
The balance has over 100 indirect memories and 5 direct memories (only CFS
50K-3 models) for frequently used tare values, average unit weights and additional
texts. These data can be accessed by calling up the corresponding number of a
certain article.
12.3.1 Store in indirect memories
CFS 3K-5, CFS 6K0.1, CFS 15K0.2, CFS 30K0.5 models:
Buttons ~ :
If necessary set balance to zero using
.
Tare, as required.
If it’s used as counting system, observe if bulk material or counting balance shall
be tared. Select using bulk material or reference balance accordingly by .
The appeared [] displays the current balance.
Or place the weighing container and tare with (see chap. 9.4.1) or enter tare
value numerically (see chapter 9.4.2).
Tare values can only be saved when they are situated in the admitted taring
range (factory setting > 2 % max).
At values < 2 % max, reset balance with .
To Next Page
Loading...
Need help?
General
