8.1 Menu selection (weight calibration / temp. calibration etc.)_______________ 84
8.1.1 P1 Calibration (adjustment) _____________________________________________ 84
8.1.2 P2 GLP (Good laboratory practice) _______________________________________ 94
8.1.3 P3 Date/time_________________________________________________________ 96
8.1.4 P4 Readout__________________________________________________________ 98
8.1.5 P5 RS-232 _________________________________________________________ 100
8.1.6 P6 Printout _________________________________________________________ 100
8.1.7 P7 General functions _________________________________________________ 107
9 Operator menu _______________________________________________ 108
9.1 Program library_________________________________________________ 108
9.2 Select heating profile ____________________________________________ 110
9.3 Select turn-off criterion __________________________________________ 111
9.4 Select calculation method ________________________________________ 112
9.5 Select interval of data output _____________________________________ 113
9.6 Enter target weight of the sample__________________________________ 114
9.7 Determine correction factor and enter ______________________________ 115
9.8 Select standard setting __________________________________________ 116
10 Call up data from the program library: __________________________ 116
11 Set drying parameters _______________________________________ 117
11.1 Select profile ___________________________________________________ 117
11.2 Select finishing criterion _________________________________________ 118
11.3 Select result calculation _________________________________________ 119
11.4 Select output interval ____________________________________________ 120
12 Carry out drying ____________________________________________ 121
13 General issues concerning moisture analyzing___________________ 123
13.1 Application ____________________________________________________ 123
13.2 Sample material ________________________________________________ 123
13.3 Sample preparation _____________________________________________ 123
13.4 Drying temperature______________________________________________ 124
13.5 Description of the heating methods ________________________________ 125
13.6 Application table (recommendations/ reference values) _______________ 126
14 Data output ________________________________________________ 127
14.1 Remote commands _____________________________________________ 128
15 Maintenance, upkeep, disposal ________________________________ 129
15.1 Cleaning ______________________________________________________ 129
15.2 Maintenance, upkeep ____________________________________________ 131
15.3 Disposal_______________________________________________________ 131
16 Troubleshooting ____________________________________________ 131
To Next Page
Loading...
