Use the foot screws to level the balance until the air bubble in the bubble level is in
the prescribed circle.
6.1.2 Scope of delivery
Standard accessories:
• Balance with moisture analyzer top piece
• Plate holder
• Extraction aid
• 10 Sample plates
• Mains cable
• Wind protection
• Instruction manual
6.2 Mains supply
Power is supplied via a mains cable.
Please check whether the voltage input of your balance is correctly set. The balance
may only be connected to the mains power if the information on the balance (sticker)
and the local mains voltage are identical.
Important:
Is the labeling (220 V 50Hz) the same as the local mains voltage?
- In case of different mains voltages do not connect!
- If the voltage is the same the balance can be connected.
6.3 Connection of peripheral equipment
The balance must be disconnected from the mains before connecting or
disconnecting additional equipment (printer, PC) to or from the data interface.
Only use KERN accessories and peripheral equipment with your balance. These
have been ideally coordinated to your balance.
Foot screw
Spirit level
To Next Page
Loading...
Need help?
General
