KERN MLS 50-3IR160 - Select Standard Setting; 10 Call up Data from the Program Library

MLS-BA-defsi-0713
11
6
9.8 Select standard setting
In this setting all sample values (temp., profile, etc..) are switched to values preset in
MLS50-3.
Operator Indication
Ö Actuate -key, use the cursor (►) to select the
desired parameter (“standard“)
Ö Actuate the -key, selection “standard“ is
activated
Use the key to accept the standard setting for the sample; with the key the old
setting remains valid.
10 Call up data from the program library:
Operator Indication
Turn on MLS50-3 on main switch (rear side)
Ö Actuate the -key to open the library
Ö Actuate the -key, use the cursor (►) to select
the saved process
Ö Push -button
Ö All set values are displayed.
Ö Moisture analyzing can be started with the -
key.