PES/PEJ-BA-e-1316
6.8. Initial Commissioning
A warming up time of 10 minutes after switching on stabilizes the measuring values.
The accuracy of the balance depends on the local acceleration of gravity.
Please be sure to observe the information in the chapter on adjusting in chap. 6.9.
6.8.1. Power display
The balance will carry out a self-test
Supply balance with power via the
mains power supply.
Balance is in stand-by mode
(green LED is on).
Use the -key to switch the bal-
ance on.
By pressing lightly it is possible to
check whether the balance display
changes.
Use the -key to switch the bal-
ance off. The balance is now in
stand-by mode again (green LED
is on).
To Next Page
Loading...
Need help?
General
