KERN PES Series - 12.5.2. Entering 3 or 4 limits by weighing

PES/PEJ-BA-e-1316
72
12.5.2. Entering 3 or 4 limits by weighing
To enter 3 or 4 limiting values [ ] - [ ] or [ ], repeat steps 7 and
8 (see also chapter 12.4.2).
Display of tolerance mark
+  [ ] 4. limiting point
 [ ] 3. limiting point
TOL   [ ] Reference weight
 [ ] 2. limiting point
 [ ] 1. limiting point
12.5.3. Numeric entering of 2 limits
Operation
Display
1. Activate tolerance weighing function
[ ] or [ ] (see chap. 7).
2. Actuate required parameter selection
or
until
[ ] or [ ] appears;
more settings of your choice (see chap.
12.3) are carried out in the same way
Parameter selection for 2 limiting points:
Parameter selection for difference value:
3. Leave function menu
g
The balance is now in tolerance weigh-
ing mode; the tolerance marker (
)
appears